
Troubleshooting
12 3A1215C
Troubleshooting
Problem Cause Solution
Control will not turn on. 12 VDC power supply low, or discon-
nected.
Connect the I/O cable.
Charge the RoadLazer battery.
Check the battery connections.
Guns will not spray. Various causes. Toggle RESET on the controller.
Check the paint supply.
Check the gun ball valves. See man-
ual 306861.
Check the RoadLazer and engine
fuses. See manual 308611 or 3A1214
and separate engine manual.
MPH readout reads zero, or inconsis-
tent reading.
Improper sensor alignment. Sensor should be .03 in. from the tim-
ing gear, and centered.
Glass beads miss a portion of a stripe
when turned on.
Paint and bead gun delays not set
properly.
Adjust Paint and Bead Gun Delay val-
ues.
Glass beads stay on longer than the
paint guns, wasting beads.
Bead Off Delay is too high. Lower the Bead Off Delay value.
Skipline is longer than the actual pro-
grammed distance.
The gun solenoids are taking longer
to turn off than to turn on.
Increase the value of the Paint Gun
on Delay.
Guns will not stop spraying. The system delay is set to ON while
the vehicle is stopped.
Gun needle and seat are worn out.
Turn the Skipline Controller’s main
power switch OFF.
Replace. See manual 308613.
Commenti su questo manuale